What samples and data are needed to test filling coolant?
Send a representative production batch of coolant, every limiting pack and the operating data needed to recreate the duty. The trial should challenge is low viscosity and may foam or attack unsuitable materials, not only demonstrate an easy short run.
What should I check first?
Record the machine state and the finished result before changing settings. This helps identify where control is first being lost.
- Provide enough coolant for setup, sustained running, stops and restart.
- Include the smallest and largest of bottles, jerrycans or drums.
- State fill tolerance, output, batch length and rejection criteria.
- Record ten consecutive fills by weight and note the product temperature, density or batch condition.
- Confirm the product supply remains stable at minimum and maximum hopper or tank levels.
Why is this production problem happening?
Work from the evidence and change one variable at a time. These are the most relevant causes to investigate first.
- The sample is fresher, warmer, thinner or more uniform than production.
- Only one nominal container is tested.
- Acceptance is based on headline speed rather than good packs.
- The dosing principle is unsuitable for viscosity, particles, aeration or accuracy.
- Product conditions are changing during the run.
How can I correct or improve it?
Make a controlled change, repeat the same measurement and compare the result before moving to the next adjustment.
- Agree a written trial matrix.
- Record fill results and interventions during the run.
- Retain approved samples and settings as the reference.
- Stabilise product temperature, mixing and supply before retuning.
- Test a representative product and pack matrix across the full fill range.
What should I send Lancing?
The most reliable recommendation is based on representative production materials and a measurable acceptance result.
- Representative sample of Coolant
- All relevant bottles, jerrycans or drums
- Target fill and tolerance
- Required accepted output
- Photographs or video of the current process
- Product name and a sample or SDS where relevant
- Viscosity, temperature, particles, foaming and density
Which applications does this answer cover?
More quick answers about this problem
What should I check first for coolant?+
Provide enough coolant for setup, sustained running, stops and restart.
Why does this problem happen with coolant?+
The sample is fresher, warmer, thinner or more uniform than production.
How can I improve or correct the problem with coolant?+
Agree a written trial matrix.
Which part of the production line does this question relate to?+
This question relates primarily to filling & dosing. It may also be affected by upstream product or pack supply and by downstream handling, so check the full production sequence rather than one machine in isolation.
What should I send when asking for a machinery recommendation?+
Send Representative sample of Coolant; All relevant bottles, jerrycans or drums; Target fill and tolerance; Required accepted output. Representative production samples and a measurable acceptance target are normally more useful than a catalogue description alone.
Explore the relevant Lancing machinery options
Review suitable equipment and application guidance, then request a recommendation based on your product, pack and required accepted output.
chemicalfillers.co.uk