How do I stop engine oil dripping onto the bottle and conveyor?
Control residual drip, oily surfaces and closure or label contamination by stabilising engine oil, its supply and the pack path before reducing speed. Use a gravity, pump, flowmeter or volumetric route with positive cutoff and drip recovery, then prove nozzle or discharge geometry, cutoff, fill motion and restart with real production material.
What should I check first?
Record the machine state and the finished result before changing settings. This helps identify where control is first being lost.
- Confirm the production condition of engine oil: is oily, medium viscosity and temperature-dependent.
- Measure the limiting pack details for bottles, jerrycans or drums, including opening, stability and fill range.
- Check that product reaches the machine through a controlled pump or flowmeter feed with drip recovery.
- Observe exactly when residual drip, oily surfaces and closure or label contamination begins.
- Compare the first, middle and final part of a batch.
Why is this production problem happening?
Work from the evidence and change one variable at a time. These are the most relevant causes to investigate first.
- The selected method does not accommodate that engine oil is is oily, medium viscosity and temperature-dependent.
- Product condition changes between the sample, start-up and a sustained run.
- Pack tolerance or presentation is influencing the measured result.
- The process is amplifying residual drip, oily surfaces and closure or label contamination.
- The outlet or pack geometry is unsuitable.
How can I correct or improve it?
Make a controlled change, repeat the same measurement and compare the result before moving to the next adjustment.
- Trial engine oil using representative production batches and the full pack matrix.
- Use a gravity, pump, flowmeter or volumetric route with positive cutoff and drip recovery.
- Plan changeover around this requirement: drain and clean oil films before the next grade.
- Change one controlled variable at a time and record the result.
- Confirm the correction during a sustained run.
What should I send Lancing?
The most reliable recommendation is based on representative production materials and a measurable acceptance result.
- Representative sample of Engine oil
- All relevant bottles, jerrycans or drums
- Target fill and tolerance
- Required accepted output
- Photographs or video of the current process
- Product name and a sample or SDS where relevant
- Viscosity, temperature, particles, foaming and density
Which applications does this answer cover?
More quick answers about this problem
What should I check first for engine oil?+
Confirm the production condition of engine oil: is oily, medium viscosity and temperature-dependent.
Why does this problem happen with engine oil?+
The selected method does not accommodate that engine oil is is oily, medium viscosity and temperature-dependent.
How can I improve or correct the problem with engine oil?+
Trial engine oil using representative production batches and the full pack matrix.
Which part of the production line does this question relate to?+
This question relates primarily to filling & dosing. It may also be affected by upstream product or pack supply and by downstream handling, so check the full production sequence rather than one machine in isolation.
What should I send when asking for a machinery recommendation?+
Send Representative sample of Engine oil; All relevant bottles, jerrycans or drums; Target fill and tolerance; Required accepted output. Representative production samples and a measurable acceptance target are normally more useful than a catalogue description alone.
Explore the relevant Lancing machinery options
Review suitable equipment and application guidance, then request a recommendation based on your product, pack and required accepted output.
liquidfillers.co.uk